Removing the sensor board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the wireless card.
4. Remove the display assembly.
5. Follow the procedure from step 1 to step 4 in “Removing the display panel”.
Procedure
1. Remove the screw (M2x2 Big Head) that secures the sensor board to the display-panel assembly.
2. Peel off the tape that secures the sensor-board cable to the sensor board.
3. Open the latch and disconnect the sensor-board cable from the sensor board.
4. Lift the sensor board off the display-panel assembly.
49
80 Removing the sensor board
To Next Page
Loading...
