Back to Contents Page
Installing Your USB Wireless Adapter
NOTE: The instructions may vary depending on the model of the wireless adapter. See the documentation that shipped with your wireless adapter for
specific instructions.
1. Install the software that shipped with your USB wireless adapter:
a. Insert the optical disc into the optical drive of your computer.
b. If the installation does not begin automatically, select Start
→ Run and then type x:\setup.exe (where x is the drive letter of your optical
drive).
c. Follow the instructions on the screen.
2. Shut down the computer.
3. Connect one end of the USB cable to the USB wireless adapter.
4. Connect the other end of the USB cable to a USB connector on your computer.
5. Turn on the computer.
Your computer automatically detects the wireless adapter and configures the software.
Related Information
Network
Setting Up Your Laptop
Setting Up Your Desktop
Setting Up a Wireless Internet Connection
Back to Contents Page
To Next Page
Loading...
