book.book Page 26 Monday, October 8, 2012 4:17 PM
Replacing the Hard Drive(s)
Procedure
1 Remove the new hard drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
2 Align the screw holes on the hard drive-bracket with the screw holes on the hard
drive.
3 Replace the screws that secure the hard-drive bracket to the hard drive.
4 Place the hard-drive assembly on the computer base.
5 Slide the hard-drive assembly to connect it to the system-board connector.
6 Replace the screws that secure the hard-drive assembly to the
computer base.
Postrequisites
1 Replace the base cover. See "Replacing the Base Cover" on page 20.
2 Replace the battery. See "Replacing the Battery" on page 13.
3 Follow the instructions in "After Working Inside Your Computer" on page 11.
26 | Hard Drive(s)
To Next Page
Loading...
