Replacing the power-button
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Using the alignment post, align the screw hole on the power-button board with
the screw hole on the display-assembly base.
2 Replace the screw (M3x5) that secures the power-button board to the display-
assembly base.
3 Adhere the power-button board cable to the display-assembly base.
4 Slide the power-button board cable into the connector on the system board and
close the latch to secure the cable.
Post-requisites
1 Replace the system-board shield.
2 Replace the back cover.
3 Replace the stand.
44
To Next Page
Loading...
