Replacing the hard drive
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
CAUTION: Hard drives are fragile. Exercise care when handling the hard drive.
Topics:
• Procedure
• Post-requisites
Procedure
1. Place the hard drive in the hard-drive bracket with the label facing up and align the screw holes on the hard drive with the screw holes
on the hard-drive bracket .
2. Replace the four screws (M3x3.5) that secure the hard-drive bracket to the hard drive.
3. Align the socket on the hard-drive assembly with the connector on the system board and slide the hard-drive assembly to connect the
hard-drive assembly to the system board.
4. Replace the screw (M3x5) that secures the hard-drive assembly to the display-assembly base.
10
Replacing the hard drive 25
To Next Page
Loading...
