Steps
1. Remove the four screws (M2X3.5) that secure the microphone module to the display-assembly base.
2. Peel the tape that secures the microphone cable to the display-assembly base.
3. Remove the microphone cable from the routing guides on the display-assembly base.
4. Lift the microphone module off the display-assembly base.
Installing the microphones
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the microphones and provides a visual representation of the installation procedure.
Removing and installing components
57
To Next Page
Loading...
