Steps
1. Remove the 10 screws (M3x5) that secure the display panel to the display-assembly base.
2. Remove the five screws (M3x3) that secure the display panel to the display-assembly base.
3. Place the computer in an upright position.
4. Holding the top corner, push the display panel away from the display-assembly base using the push holes available on the
display-assembly base.
5. Slide the display-backlight cable, touchscreen cable, and display cable on the display panel through the slots on the display-
assembly base.
6. Lift the display panel up from the display-assembly base.
62
Removing and installing components
To Next Page
Loading...
