Replacing the headset port
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Slide the headset port into its slot on the middle frame and align the screw hole on the headset port to the screw hole on the display-
assembly base.
2 Replace the screw (M3x5) that secures the headset port to the display-assembly base.
Post-requisites
1 Replace the I/O board.
2 Replace the speakers.
3 Replace the rear-I/O bracket.
4 Replace the base cover.
5 Replace the system-board shield.
6 Replace the back cover.
7 Replace the stand.
41
Replacing the headset port 67
To Next Page
Loading...
