Procedure
NOTE: The following procedure only applies to computers shipped with Full High Denition (FHD) displays.
1 Align the screw holes on the system board with the screw holes on the display-assembly base.
2 Replace the nine screws (M3x5) that secure the system board to the display-assembly base.
3 Connect the power-adapter cable to the system board.
4 Connect the display-backlight cable to the system board.
5 Connect the camera cable to the system board.
6 Connect the fan cable to the system board.
7 Connect the I/O-board cable to the system board.
8 Connect the I/O-board power cable to the system board.
9 Connect the headset-port cable to the system board.
10 Connect the speaker cable to the system board.
11 Connect the microphones cable to the system board.
12 Connect the power-button board cable to the system board and close the latch to secure the cable.
Replacing the system board
77
To Next Page
Loading...
