Figure 15. Installing the stand
Insert the stands into the slots on the back cover until they snap into place on the display-assembly base.
Next steps
Follow the procedure in After working inside your computer.
Back cover
Removing the back cover
Prerequisites
1. Follow the procedure in Before working inside your computer.
CAUTION:
When servicing the computer, place it on an elevated, clean, and flat surface. Place the display
flat on the surface with the stand over the edge. It is recommended to remove the stand to avoid accidental
damage to the computer display when servicing.
Figure 16. Caution for stand
44
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
