About this task
The following image indicates the location of the back cover and provides a visual representation of the removal procedure.
Figure 17. Removing back cover
Steps
1. Place your palm in the middle of the back cover, and then pry the back cover from the display-assembly base starting from
the top corners.
2. Remove the back cover from the display-assembly base.
Installing the back cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the back cover and provides a visual representation of the installation procedure.
Removing and installing Customer Replaceable Units (CRUs)
45
To Next Page
Loading...
