Figure 24. Installing the system-board shield
Steps
1. Align the screw holes on the system-board shield with the slots on the display-assembly base.
2. Place system-board shield on the display-assembly base.
3. Replace the four screws (M3x5) that secure the system-board shield to the display-assembly base.
Next steps
1. Install the I/O cover.
2. Install the back cover.
3. Install the stand.
4. Follow the procedure in After working inside your computer.
Hard drive
Removing the hard drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the stand.
3. Remove the back cover.
About this task
The following image indicates the location of the hard drive and provides a visual representation of the removal procedure.
52
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
