Figure 49. Removing the media-card reader
Steps
1. Remove the screw (M3x3.5) that secures the media-card reader to the display-assembly base.
2. Open the latch and disconnect the media-card reader cable from the system board.
3. Gently slide and remove the media-card reader, along with its cable, from the media-card reader slot.
Installing the media-card reader
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the media-card reader and provides a visual representation of the installation
procedure.
76
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
