Figure 66. Replacing the screws
Steps
1. Slide and insert the display panel into the slot on the display-assembly base.
2. Route the display-backlight cable, touchscreen cable, and display cable on the display panel through the slots on the
display-assembly base.
3. Place the display-assembly base on a clean and flat surface with the display panel facing down.
4. Replace the 12 screws (M3x5) that secure the display panel to the display-assembly base.
5. Replace the five screws (M3x3) that secure the display panel to the display-assembly base.
NOTE:
The screws that secure the middle frame and display panel to the display-assembly base are silver in color and
etched with "LCD" around the screw holes.
Next steps
1. Install the system board.
2. Install the integrated heat sink or, discrete heat sink.
3. Install the M.2 2230 solid-state drive or, M.2 2280 solid-state drive, which ever applicable.
4. Install the wireless card.
5. Install the media-card reader.
6. Install the system-board shield.
7. Install the hard drive.
8. Install the I/O cover.
9. Install the back cover.
10. Install the stand.
11. Follow the procedure in After working inside your computer.
94
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
