Procedure
1.
NOTE: Applicable only to computers that are shipped with optical drive.
Align the tabs on the optical-drive bezel with the slots on the optical drive and snap the optical-drive bezel into place.
2.
Align the screw holes on the optical-drive bracket with the screw holes on the optical drive.
3. Replace the two screws (M2x3) that secure the optical-drive bracket to the optical drive.
4. Slide the optical-drive assembly into the optical-drive bay.
5. Align the screw hole on the optical-drive bracket with the screw hole on the base cover. Replace the screw (M2x2) that secures the
optical-drive assembly to the base cover.
12
Removing and installing components
To Next Page
Loading...
