9. Press and hold the power button for five seconds to ground the computer and drain the flea power.
Replacing the base cover
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure for computers shipped without optical drive
1. Connect the battery cable to the system board and adhere the tape that secures the battery cable to the connector on the system
board, if applicable.
2. Place the base cover on the palm-rest and keyboard assembly.
3. Snap the base cover into place starting from the power-adapter port.
CAUTION:
To avoid accidental damage to the power-adapter port, do not press the base cover against the power-
adapter port when you snap the base cover to the computer base.
16 Removing and installing components
To Next Page
Loading...
