5. Route the display cable through the hook on the right hinge and close the right hinge.
6. Replace the two screws (M2.5x5) that secure the right hinge to the palm-rest and keyboard assembly.
NOTE: For computers shipped without optical drive, there is an additional screw on the right hinge that secures the
right hinge to palm-rest and keyboard assembly.
Post-requisites
1. Replace the fan.
2. Replace the base cover.
3. Replace the optical drive (applicable only to computers shipped with optical drive).
System board
Removing the system board
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
54 Removing and installing components
To Next Page
Loading...
