Steps
1. Lay the computer with its right side facing down.
2. Remove the three screws (6-32) that secure the power supply to the chassis.
3. Disconnect the power-supply cables from the system board.
NOTE:
The power-supply cable is connected to the system board at two locations and supply power to the following
components at the two location:
• Processor
• System board
4. Remove the power-supply cables from the routing guides on the chassis.
5. Press down on the securing clip to release the power supply from the chassis.
6. Slide and lift the power supply from its slot on the chassis.
Installing the power supply
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing components
25
To Next Page
Loading...
