About this task
The following image(s) indicate the location of the power button and provides a visual representation of the installation
procedure.
Steps
1. Slide the power-button cable through the slot on the front of the chassis.
2. While pressing the tabs on the power button insert it through the slot on the chassis and then secure it into place.
3. Connect the power-button cable to the system board.
4. Place the computer in an upright position.
Next steps
1. Install the hard drive.
2. Install the front cover.
3. Install the left-side cover.
4. Follow the procedure in After working inside your computer.
Graphics card
Removing the graphics card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
NOTE: Depending on the configuration ordered, your computer may not have a discrete graphics card installed.
The following image(s) indicate the location of the graphics card and provides a visual representation of the removal procedure.
24
Removing and installing components
To Next Page
Loading...
