Solving Problems 71
Printer Problems
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTE: If you need technical assistance for your printer, contact the printer’s
manufacturer.
IF THE POWER LIGHT IS BLINKING AMBER — The computer is receiving electrical
power, a device might be malfunctioning or incorrectly installed.
• Remove and then reinstall the memory modules (see "Installing Memory" on
page 111).
• Remove and then reinstall any cards (see "Cards" on page 114).
• Remove and then reinstall the graphics card, if applicable (see "Removing a
PCI/PCI Express Card" on page 119).
ELIMINATE INTERFERENCE — Some possible causes of interference are:
• Power, keyboard, and mouse extension cables.
• Too many devices on a power strip.
• Multiple power strips connected to the same electrical outlet.
CHECK THE PRINTER DOCUMENTATION — See the printer documentation for
setup and troubleshooting information.
ENSURE THAT THE PRINTER IS TURNED ON
CHECK THE PRINTER CABLE CONNECTIONS —
• See the printer documentation for cable connection information.
• Ensure that the printer cables are securely connected to the printer and the
computer (see "Setting Up a Printer" on page 23).
TEST THE ELECTRICAL OUTLET — Ensure that the electrical outlet is working by
testing it with another device, such as a lamp.
book.book Page 71 Monday, December 10, 2007 3:12 PM
To Next Page
Loading...
