162 Removing and Installing Parts
Installing the I/O Panel
1
Place the I/O panel into the slot.
NOTICE: Take care not to damage the cable connectors and the cable routing clips
when sliding the I/O panel into the computer.
2
Replace and tighten the screw that secures the I/O panel to the chassis.
3
Reconnect the cables to the system board.
4
Replace the bezel (see "Replacing the Bezel" on page 136).
5
Replace the computer cover (see "Replacing the Computer Cover" on
page 174).
6
Connect your computer and devices to an electrical outlet, and turn
them on.
7
Verify that the computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 88).
1 I/O panel 2 screw
2
1
book.book Page 162 Monday, October 6, 2008 11:38 AM
To Next Page
Loading...
