Dell Inspiron 6000 PP12L - Enabling the Display Settings for a TV

Using CDs, DVDs, and Other Multimedia 37
5 Plug the single-connector end of the audio cable in to the headphone connector on the
computer.
6 Plug the two RCA connectors on the other end of the audio cable in to the audio input
connectors on your TV or other audio device.
7 Turn on the TV and any audio device that you connected (if applicable), and then turn on the
computer.
8 See "Enabling the Display Settings for a TV" on page 37 to ensure that the computer
recognizes and works properly with the TV.
Enabling the Display Settings for a TV
Your computer may have either a video-controller card or a video controller on the system board
(known as an
integrated video controller). See the following subsection that corresponds to the
video controller installed in your computer.
Video-Controller Card
NOTE: Ensure that you properly connect the TV before you enable the display settings.
1 Click the Start button and click Control Panel .
2 Click Appearances and Themes .
3 Under or pick a Control Panel icon , click Display .
4 Click the Settings tab and click Advanced .
5 Click the Displays tab.
6 Click the upper-left corner of the TV button to enable the TV.
7 Click OK .
Integrated Video Controller
NOTE: Ensure that you properly connect the TV before you enable the display settings.
1 Click the Start button and click Control Panel .
2 Click Appearances and Themes .
3 Under or pick a Control Panel icon , click Display .
4 Click the Settings tab and click Advanced .