Solving Problems 57
If the message is not listed, see the documentation for the operating system or the program that
was running when the message appeared.
BAD COMMAND OR FILE NAME — Ensure that you have spelled the command correctly, put spaces in
the proper place, and used the correct pathname.
CD DRIVE CONTROLLER FAILURE — The CD drive does not respond to commands from the computer.
See "Drive Problems" on page 53.
DATA ERROR — The hard drive cannot read the data. See "Drive Problems" on page 53.
THE FILE BEING COPIED IS TOO LARGE FOR THE DESTINATION DRIVE — The file that you are trying
to copy is too large to fit on the disk, or the disk is too full. Try copying the file to a different disk or use
a larger capacity disk.
A FILENAME CANNOT CONTAIN ANY OF THE FOLLOWING CHARACTERS: \ / : * ? “ < > | — Do not
use these characters in filenames.
INSERT BOOTABLE MEDIA — The operating system is trying to boot to a nonbootable CD.
Insert a CD.
NOT ENOUGH MEMORY OR RESOURCES. EXIT SOME PROGRAMS AND TRY AGAIN — You have too
many programs open. Close all windows and open the program that you want to use.
OPERATING SYSTEM NOT FOUND — Reinstall the hard drive. See page 77. If the problem persists,
contact Dell. See "FCC Notices (U.S. Only)" on page 102.
A REQUIRED .DLL FILE WAS NOT FOUND — The program that you are trying to open is missing an
essential file. Remove and then reinstall the program.
1
Click the
Start
button and click
Control Panel
.
2
Click
Add or Remove Programs
.
3
Select the program you want to remove.
4
Click
Remove
or
Change/Remove
and follow the prompts on the screen.
5
See the program documentation for installation instructions.
X :\ IS NOT ACCESSIBLE. THE DEVICE IS NOT READY — Insert a disk into the drive and try again.
To Next Page
Loading...
