Adding and Replacing Parts 81
NOTICE: If you need to install memory modules in two connectors, install a memory module in the
connector labeled “DIMMA” before you install a module in the connector labeled “DIMMB.” Insert
memory modules at a 45-degree angle to avoid damaging the connector.
NOTE: If the memory module is not installed properly, the computer may not boot properly. No error
message indicates this failure.
5
Ground yourself and install the new memory module:
a
Align the notch in the module edge connector with the tab in the connector slot.
b
Slide the module firmly into the slot at a 45-degree angle, and rotate the module down
until it clicks into place. If you do not feel the click, remove the module and reinstall it.
6
Replace the memory module cover.
NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close
may damage your computer.
notch
tab
To Next Page
Loading...
