Adding and Replacing Parts 87
3
Remove the four screws securing the display.
4
Disconnect the antennae cables (pull to separate the connectors).
5
Remove the grounding wire screw.
6
Disconnect the display cable, using the pull-tab.
7
Lift the display up and away from the computer.
When you replace the display, ensure that the display cable is lying flat in the display cable trough
and securely tucked underneath the tabs.
Also, ensure that the antenna cables are not twisted and that they are lying flat in the antenna
cable clip.
screws (4)
display cable pull-tab
display cable connector
on system board
grounding wire screw
antenna cables
display cable trough
antenna cable clip
To Next Page
Loading...
