Dell Inspiron 600m - Right Side View Component Identification

Back to Contents Page
Palm Rest
Dell™Inspiron™600mServiceManual



1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the keyboard.

3. Remove the display assembly.
4. Remove the three M2 x 3-mm screws labeled "circle P" from the top of the palm rest.


5. Disconnect the touch pad connector from the system board.

CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest; the display hinges pass through the back of the palm rest.
1
M2 x 3-mm screws (3)
2
top of the palm rest