4. Insert the memory module into the connector until the memory module snaps into position.
If you insert the memory module correctly, the securing clips snap into the cutouts at each end of the memory module.
5. Replace the computer cover (see Replacing the Computer Cover).
6. Connect your computer and devices to electrical outlets, and then turn them on.
If a message appears stating that the memory size has changed, press <F1> to continue.
7. Log on to your computer.
To verify that the memory is installed correctly, click Start ® Control Panel® System.
Check the amount of memory (RAM) listed.
Back to Contents Page
CAUTION: To avoid damage to the memory module, press the memory module straight down into the connector while you apply equal force to
each end of the memory module.
To Next Page
Loading...
