Removing and Replacing Parts 4-37
'LVSOD\$VVHPEO\
This section provides the removal procedure for the display assembly.
)LJXUH'LVSO D\$VVHPEO\5HPRYDO
This procedure assumes that you have removed the keyboard and thermal
shield. To remove the display assembly from the computer, follow these steps
(see Figure 4-24):
1. Disconnect the LCD wire harness from connector JP3.
Use a dental pick or flat-blade screwdriver to pry up each end of the con-
nector to release it.
2. Close the display.
3. Remove the four 6-mm screws that secure the two hinges.
4. Unlatch the display assembly and lift the assembly off the computer base.
6-mm screws (4)
hinge saddles (2)
connector
JP3
hinges (2)
LCD wire
harness
To Next Page
Loading...
