Dell Inspiron 7000 - Page 80

Removing and Replacing Parts 4-45
03(*&DUG
This section provides the removal procedure for the MPEG-2 card, if present.
)LJXUH03(*&DUG5HPRYDO
To remove the MPEG-2 card, follow these steps (see Figure 4-29):
1. Gently pull the carrier tray off of connector JP19 on the system board. Do
not rock the card to remove it, because this may damage the connectors.
2. Remove the carrier tray by sliding it toward the back of the computer
3. Remove the MPEG-2 card from the carrier tray.
carrier tray
(MPEG-2 card inside)