Dell Inspiron 7390 2n1 - 6 Removing the Base Cover; Procedure

Removing the base cover
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Loosen the two captive screws that secure the base cover to the palm-rest assembly.
2 Remove the six screws (M2x4) that secure the base cover to the palm-rest assembly.
3 Using a plastic scribe, pry the base cover from the tabs on the hinges and continue to pry the base cover from the slots on the palm-
rest assembly.
CAUTION
: Do not pry the base cover from the middle as it might damage the chassis.
4 Carefully remove the base cover o the palm-rest assembly.
6
14 Removing the base cover