Dell Inspiron 7390 2n1 - 35 Replacing the Power Button with Fingerprint Reader; Procedure; Post-Requisites

Replacing the power button with ngerprint
reader
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
NOTE: Applicable only for computers that are shipped with ngerprint reader.
Procedure
1 Align the power button with ngerprint reader on the keyboard bracket and adhere the tape that secures the power button with
ngerprint reader on the keyboard bracket.
2 Place the power button with ngerprint reader on the keyboard bracket.
3 Connect the ngerprint-reader cable to power button with ngerprint reader and close the latch to secure the cable.
4 Follow the procedure from step 3 to step 8 in "Replacing the keyboard".
Post-requisites
1 Replace the system board.
2 Replace the I/O board.
3 Replace the display assembly.
4 Replace the fan.
35
Replacing the power button with ngerprint reader 63