58 | Power-Button Assembly
Procedure
1 Disconnect the power-button and hard-drive activity light cable from the
connector (PWRCN1) on the system board.
2 Make a note of the power-button and hard-drive activity light cable routing and
remove it from the routing guides.
3 Remove the screw that secures the power-button assembly to the middle frame.
4 Slide the power-button assembly toward the top of the computer and then lift it
away from the middle frame.
1 screw 2 power-button assembly
3 power-button and
hard-drive activity light cable
book.book Page 58 Monday, April 16, 2012 3:04 PM
To Next Page
Loading...
