Dell Inspiron One 2205 - Display Bezel; Removing the Display Bezel

Back to Contents Page
 Display
Dell™Inspiron™One2205ServiceManual
Display Bezel
Display Panel
Display Cable


Display Bezel

Removing the Display Bezel

1. Follow the instructions in Before You Begin.

2. Remove the system board (see Removing the System Board).

3. Remove the 19 screws that secure the display bezel to the chassis.

4. Carefully peel the silver foil that adheres the camera module to the chassis from the chassis.

5. Make a note of the camera cable, infrared-card cable, and Bluetooth
®
-card cable routing and release the cables through the slots on the chassis.

6. Turn the computer over.

7. Release the three tabs that secure the display bezel to the chassis.

8. Using your fingertips, carefully pry up the inside edge of the display bezel.

9. Lift the display bezel away from the computer.

10. Remove the camera module (see Removing the Camera Module).

11. Remove the infrared card (see Removing the Infrared Card).

12. Remove the Bluetooth card (see Removing the Bluetooth Card).
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).