Dell Inspiron One 2205 - Set Up Inspiron One Operating System


Replacing the Display Panel

1. Follow the instructions in Before You Begin.

2. Guide the display cable through the slot on the chassis.

3. Align the screw holes on the display panel with the screw holes on the chassis.

4. Replace the four screws that secure the display panel to the chassis.

5. Follow the instructions from step 5 to step 12 in Replacing the Display Bezel.


6. Connect your computer and all attached devices to electrical outlets, and turn them on.
Display Cable

Removing the Display Cable

1. Follow the instructions in Before You Begin.

2. Remove the display panel (see Removing the Display Panel).

3. Turn the display panel over.

4. Pull the pull-tab to disconnect the display cable from the connector on the display panel.
1
screws (4)
2
display panel
NOTE: The number of screws that secure the display panel to the chassis may vary.
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.