Dell Inspiron One 2205 - Page 23

Back to Contents Page
 Front Stand
Dell™Inspiron™One2205ServiceManual
Removing the Front Stand
Replacing the Front Stand


Removing the Front Stand

1. Follow the instructions in Before You Begin.

2. Remove the back cover (see Removing the Back Cover).

3. Remove the three screws that secure the front-stand assembly to the computer.

4. Lift the rear stand so that the front stand is accessible.

5. Carefully push and release the tab that secures the front-stand assembly to the middle frame.

6. Release the tabs that secure the I/O bracket to the middle frame.

7. Lift the front-stand assembly away from the computer.

8. Remove the three screws that secure the I/O bracket to the front stand.

9. Release the four tabs that secure the I/O bracket to the front stand.

10. Remove the I/O bracket from the front stand.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
screws (3)
2
rear stand
3
tab
4
front-stand assembly