Dell Inspiron One 2205 - Using Support Tools; Access Dell Support Center for Assistance

Back to Contents Page
 Processor
Dell™Inspiron™One2205ServiceManual
Removing the Processor
Replacing the Processor


Removing the Processor

1. Follow the instructions in Before You Begin.

2. Remove the back cover (see Removing the Back Cover).

3. Follow the instructions from step 3 to step 7 in Removing the Front Stand.

4. Remove the rear stand cover (see Removing the Rear Stand Cover).

5. Remove the system-board shield (see Removing the System-Board Shield).

6. Remove the MXM-assembly fan (see Removing the MXM-Assembly Fan).

7. Remove the MXM assembly (see Removing the MXM Assembly).

8. Remove the processor heat-sink fan (see Removing the Processor Heat-Sink Fan).

9. Remove the processor heat-sink (see Removing the Processor Heat-Sink).

10. Press and push the release lever down and out to release it from the tab that secures it.


WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
processor
2
release lever
3
processor socket
CAUTION: When removing or replacing the processor, do not touch any of the pins inside the processor socket or allow any objects to fall on the
pins in the processor socket.