4. Lift the optical drive connector away form the computer.
Installing the optical drive connector
1. Place the optical drive on to the computer.
2. Connect the optical drive connector cable.
3. Press the locking tab.
4. Tighten the screws that secure the optical drive connector to the computer.
5. Flip the optical drive connector and seat it.
6. Tighten the screws to secure the optical drive connector to the computer.
7. Install the:
a. base cover
b. optical drive
c. hard drive
d. battery
8. Follow the procedure in After working inside your computer.
Hard drive tray
Removing the hard drive tray
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To remove the hard drive tray:
a. Peel the adhesive tape [1].
b. Lift the latch [2] and disconnect the hard drive cable from the connector [3].
c. Lift the latch [4] and disconnect the system board cable from the connector [5].
Disassembly and reassembly
23
To Next Page
Loading...
