Installing the RF holder
1. Place the RF holder on the computer.
2. Install the screws that secure the RF holder to the computer.
3. Connect the antenna cables.
4. Route the antenna cables.
5. Install the:
a. docking board
b. WLAN card
c. GPS board
d. base cover
e. optical drive
f. hard drive
g. battery
6. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To release the display assembly:
a. Lift the latch [1] and disconnect the I/O cable from the connector on the system board [2].
b. Remove the screws that secure the metal tab [3].
c. Lift the metal tab to access the eDP cable [4].
d. Disconnect the eDP cable on the system board [4].
36
Disassembly and reassembly
To Next Page
Loading...
