b. Lift the latch [1] and disconnect the I/O board cable from the connector [2].
c. Peel the adhesive tape [4] and disconnect the display cable [5].
5. To remove the I/O board:
a. Remove the screws that secure the I/O board to the computer [1].
b. Lift the I/O board away from the computer [2].
Installing the I/O board
1. Place the I/O board on the computer.
2. Tighten the epoxy screws to secure the I/O board to the computer.
3. Connect the display assembly cable to the computer.
4. Connect the I/O cable to the computer.
5. Tighten the screw to secures the I/O board.
Disassembly and reassembly
41
To Next Page
Loading...
