5. Follow the procedure in After working inside your computer.
Driving board
Removing the driving board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To remove the driving board:
a. Peel the adhesive tape to access the display assembly cable [1].
b. Disconnect the display assembly cable [2].
c. Peel the adhesive tape to access the I/O cable [3].
d. Disconnect the I/O cable [4].
e. Remove the screws that secure the driving board to the computer [5].
f. Lift the driving board from the computer [6].
Installing the driving board
1. Place the driving board on the computer.
2. Tighten the screws that secure the driving board on the computer.
3. Connect the I/O board cable.
4. Affix the adhesive tape.
5. Connect the display assembly cable
6. Affix the adhesive tape.
7. Install:
a. base cover
b. hard drive
Disassembly and reassembly
43
To Next Page
Loading...
