Installing the driving board
1. Place the driving board on the computer.
2. Tighten the screws that secure the driving board on the computer.
3. Connect the I/O board cable.
4. Affix the adhesive tape.
5. Connect the display assembly cable
6. Affix the adhesive tape.
7. Install:
a. base cover
b. hard drive
c. optical drive
d. battery
8. Follow the procedure in After working inside your computer.
Battery connector
Removing the battery connector
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
e. I/O board
43
To Next Page
Loading...
