3. To remove the battery connector:
a. Disconnect the battery connector cable [1].
b. Remove the screws that secure the battery connector [2].
c. Lift the battery connector [3].
Installing the battery connector
1. Place the battery connector on the system board.
2. Tighten the screws to secure the battery connector to the computer.
3. Connect the battery connector cable.
4. Install the:
a. I/O board
b. base cover
c. optical drive
d. hard drive
e. battery
5. Follow the procedure in After working inside your computer.
System board
Removing the system board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. battery
b. hard drive
c. optical drive
44
To Next Page
Loading...
