4. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the keyboard door [1].
b. Lift the locking tab [2].
c. Disconnect the keyboard cables from the system board [3].
5. Lift and remove the keyboard from the computer chassis
Installing the Keyboard
1. Connect the keyboard cables to its connectors on the keyboard controller card.
2. Place the keyboard door over its slot on the computer chassis.
3. Tighten the screws that secure the keyboard door to the computer chassis.
4. Align the keyboard into its slot on the computer.
5. Tighten the screws to secure the keyboard to the computer.
6. Install:
13
To Next Page
Loading...
