Dell Latitude 14 Rugged - Installing the WWAN Card; Removing the GPS Holder

Installing the WWAN Card
1. Insert the WWAN card in the slot.
2. Connect the screw to secure the WWAN.
3. Connect the cables to the WWAN card.
4. Install:
a. GPS Holder
b. Bottom Cover
c. Optical Drive
d. Hard Drive
e. Battery
5. Follow the procedures in After Working Inside Your computer
Removing the GPS Holder
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
3. Perform the following steps as shown in the illustration:
a. Unroute the antenna cable [1].
b. Remove the screw that secure the GPS holder to the computer [2].
c. Lift the holder from the computer [3].
19