Dell Latitude 14 Rugged - Removing the GPS Holder; Installing the RF Holder

b. WWAN Card
c. Bottom Cover
d. Optical Drive
e. Hard Drive
f. Battery
6. Follow the procedures in After Working Inside Your computer
Removing the GPS Holder
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
3. Perform the following steps as shown in the illustration:
a. Unroute the antenna cable [1].
b. Remove the screw that secure the GPS holder to the computer [2].
c. Lift the holder from the computer [3].
Installing the RF Holder
1. Place the RF holder into its place on the computer.
2. Tighten the screw that secure the holder to the computer.
3. Connect the antenna cable.
4. Align the cable to the computer.
5. Install:
a. Docking Board
b. WLAN Card
c. GPS Holder
d. Bottom Cover
23