4. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the SSD bracket to the computer [1].
b. Lift the SSD bracket from the computer [2].
Installing the SSD Bracket
1. Place the SSD bracket on the computer.
2. Tighten the screws that secure the SSD connector
3. Affix the adhesive tape to the computer
4. Connect the SSD braket cable to the computer.
5. Install:
a. Bottom Cover
b. Optical Drive
c. Hard Drive
d. Battery
6. Follow the procedures in After Working Inside Your computer
Removing the USH Board
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
30
To Next Page
Loading...
