Steps
1. For systems shipped with an SSD: Remove the single screw (M2x3) that secures the SSD thermal plate to the system board.
Remove the thermal plate from the system board.
2. Remove the four screws (M2x3) that secure the heatsink assembly to the system board.
3. Lift and remove the heatsink assembly from the system board.
Installing the heatsink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the heatsink assembly and provides a visual representation of the installation
procedure.
38
Removing and installing components
To Next Page
Loading...
