Steps
1. Align and replace the heatsink assembly into its slot on the system board.
2. Replace the four screws (M2x3) to secure the heatsink assembly to the system board.
3. For systems shipped with an SSD: Align and replace the single screw (M2x3) that secures the SSD thermal plate to the
system board.
Next steps
1. Install the palmrest and keyboard assembly.
2. Follow the procedure in after working inside your computer.
Dummy battery cell
Removing the dummy battery cell
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
Removing and installing components
39
To Next Page
Loading...
