Next steps
1. Install the display hinges.
2. Install the display cable.
3. Install the front-facing camera.
4. For 2-in-1 systems, install the touch-panel assembly
5. Install the display panel.
6. Install the display bezel.
7. Install the display assembly.
8. Install the palmrest and keyboard assembly.
9. Follow the procedure in after working inside your computer.
Base cover assembly
Replacing the base cover assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the palmrest and keyboard assembly.
3. For systems that are shipped with a Solid State Drive (SSD), remove the solid-state drive.
4. Remove the speakers.
5. Remove the audio board.
6. Remove the 3-cell battery or the 4-cell battery depending on the system configuration.
7. Remove the display assembly.
8. Remove the power adapter port.
9. For systems shipped with a world-facing camera, remove the world-facing camera.
10. Remove the heatsink assembly.
11. For systems that are shipped with a 3-cell battery, remove the dummy battery cell.
12. Remove the system board.
About this task
After performing the preceding steps, you are left with the base cover assembly.
64
Removing and installing components
To Next Page
Loading...
