3 Remove the battery.
The following image indicates the location of speakers and provides a visual representation of the removal procedure.
1 Open the latch and disconnect the touchpad cable from the system board.
2 Disconnect the speaker cable from the system board.
3 Peel the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4 Note the routing of the speaker cable and remove the speaker cable from the routing guides on the palm-rest and keyboard assembly.
NOTE
: Note the position of the rubber grommets before lifting the speakers.
5 Lift the speakers, along with the cable, o the palm-rest and keyboard assembly.
Installing the speakers
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of speakers and provides a visual representation of the installation procedure.
28
Removing and installing components
To Next Page
Loading...
